Breaking News
Home / Sys Admin / Unix / How to concatenate files in Unix?

How to concatenate files in Unix?

NAME
     cat — concatenate and print files

SYNOPSIS
     cat [-benstuv] [file …]

DESCRIPTION
     The cat utility reads files sequentially, writing them to the standard output.  The file operands are processed in command-line order.  If file is a single dash (-') or absent, cat reads from the standard input.  If file is a UNIX domain
     socket, cat connects to it and then reads it until EOF.  This complements the UNIX domain binding capability available in inetd(8).

     The options are as follows:

     -b      Number the non-blank output lines, starting at 1.

     -e      Display non-printing characters (see the -v option), and display a dollar sign ($’) at the end of each line.

     -n      Number the output lines, starting at 1.

     -s      Squeeze multiple adjacent empty lines, causing the output to be single spaced.

     -t      Display non-printing characters (see the -v option), and display tab characters as ^I'.

     -u      Disable output buffering.

     -v      Display non-printing characters so they are visible.  Control characters print as ^X’ for control-X; the delete character (octal 0177) prints as ^?'.  Non-ASCII characters (with the high bit set) are printed as M-‘ (for meta)
             followed by the character for the low 7 bits.

EXIT STATUS
     The cat utility exits 0 on success, and >0 if an error occurs.

EXAMPLES
     The command:

           cat file1

     will print the contents of file1 to the standard output.

     The command:

           cat file1 file2 > file3

     will sequentially print the contents of file1 and file2 to the file file3, truncating file3 if it already exists.  See the manual page for your shell (i.e., sh(1)) for more information on redirection.

     The command:

           cat file1 – file2 – file3

     will print the contents of file1, print data it receives from the standard input until it receives an EOF (^D') character, print the contents of file2, read and output contents of the standard input again, then finally output the con-
     tents of file3.  Note that if the standard input referred to a file, the second dash on the command-line would have no effect, since the entire contents of the file would have already been read and printed by cat when it encountered the
     first
-‘ operand.

[pb_builder]

Check Also

How to list disks information in Linux?

In order to check the disk in the system we can use the List Hardware …

Advertisment ad adsense adlogger